h 82,040 Watts W and storage capacities up to 100 gallons gal 379 liters L and constructed to Underwriters Laboratories, Inc UL or American Society of Mechanical Engineers ASME requirements.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9

A-A-50549

7.1.6 The Federal Acquisition Regulation (FAR) may be obtained from the Superintendent of

Documents, U.S. Government Printing Office, Washington, DC 20402.

7.2 Ordering data. Acquisition documents should specify the following:

a. Type and size required (see 2.).

b. When water heater shall be suitable for installation in an alcove or closet (see 3.5). c. When water heater shall be suitable for installation on non-combustible floor or

combustible floor (see 3.5).

d. Whether heat content of fuel is 138,500 Btu/gal (496,924 kJ/L) or 140,000 Btu/gal

(502,306 kJ/L) (see 3.6).

e. When electrical characteristics are different (see 3.8). f. When motor starter is required (see 3.8).

g. When voltage to controls shall be different (see 3.9). h. Accessories required (see 3.10).

i. Level of preservation, packing and marking required (see 6.).

7.3 Part Identification Number (PIN). The following part identification numbering procedure is for government purposes and does not constitute a requirement for the contractor. The PINs to be used for items acquired to this description are created as follows:

AA50549-04-35

CID number

Type and number (see 7.3.1)

Size and minimum firing rate (see 7.3.2)

7.3.1 Type. The type of the heater (see 2) is identified by a two-digit number (see table III).

TABLE III. Code number to type.

Tank type Code number

I 04

II 09

7.3.2 Size and minimum firing rate. The size and minimum firing rate of the heater (see 2.) are identified by a two-digit number (see table IV).